Setting The Port Select Parameter - Yamaha AW4416 Operation Manual

Chapter15—MIDI
Apple Macintosh series: 8-pin system peripheral cable
In the case of some Macintosh computers that have no modem/printer cable, it is
not possible to make direct connections to the AW4416's TO HOST connector.

Setting the PORT SELECT parameter

In order to use the TO HOST connector, the AW4416's PORT SELECT parameter
must be set appropriately for the type of computer that is selected.
1. Press [MIDI], and then press the [F1] key.
The MIDI Setup page will appear, allowing you to make MIDI-related settings for
the AW4416.
2. Move the cursor to the PORT SELECT knob, and use the [DATA/JOG] dial
to select the setting appropriate for your computer.
The following types of computer require the following PORT SELECT parameter
settings.
• IBM/PC series: TO HOST PC 2 (38.4 kbps)
• Apple Macintosh series (models with modem/printer port): TO HOST MAC
• Depending on your system, you may need separate driver software in order to
• When connecting to a Macintosh, you must set the MIDI interface clock set-
234
— Operation Guide
mini DIN 8-pin
1
7
2
6
8
3
3 5
4
4
5
6
1 2
7
8
make serial port connections.
ting of your application to 1 MHz.
mini DIN 8-pin
2 (HSK i)
7
1 (HSK O)
6
8
5 (RxD -)
3 5
4 (GND)
4
3 (TxD -)
8 (RxD +)
1 2
7 (GPI)
6 (TxD +)