Locating To A Specific Point - Yamaha AW4416 Operation Manual

Chapter6—Transport/locate operations
Locating to a specific point
You can directly specify a locate point as a numerical value, and locate to it.
Here's how.
1. With the transport stopped, press the [NUM LOCATE] key of the Locate
section.
If you have selected a screen where normal transport operations cannot be per-
formed, such as the SONG screen or the MASTERING screen, the [NUM
LOCATE] key cannot be used even if the cursor is displayed at the counter in the
upper part of the display.
The cursor will move to the counter in the upper part of the display.
2. To specify the locate point using the [DATA/JOG] dial, use the CURSOR
[ ]/[
and rotate the [DATA/JOG] dial to specify the value.
3. To specify the locate point using the numeric keys (keys 0–9 of the
locate section), move the cursor to the lowest digit of the value you wish
to input, and use the numeric keys to directly input the value.
If the time display (SECOND) is selected as the counter display type, you can
specify the value as hours/minutes/seconds/milliseconds; if time code display
(TIME CODE) is selected, you can specify hours/minutes/seconds/frames/sub-
frames; if measure display (MEASURE) is selected, you can specify measures/
beats.
4. To execute the Locate operation, press the [ENTER] key.
114
— Operation Guide
LOCATE
AUTO
PUNCH
REPEAT
] keys to move the cursor to the digit that you wish to change,
MARK SEARCH
7 8 9
NUM
MARK
LAST REC LAST REC
4 5 6
IN OUT SET
1 2 3
A B ROLL
BACK
0
CANCEL
RTZ
NO
Cursor