Yamaha AW4416 Operation Manual page 159

Chapter8—Patching
3. Move the cursor to the EXECUTE button in the lower right of the display,
and press the [ENTER] key.
A popup window will appear, asking you to confirm execution of Quick Rec.
4. To execute the Quick Rec settings, move the cursor to the OK button
and press the [ENTER] key.
All [REC TRACK SELECT] keys will blink, and the input patch settings and mix
parameters of each channel will be reset. At this time, the signal flow will be as
follows.
OPTION I/O
slot 1
I/O
card
OPTION I/O
slot 2
I/O
card
Tip!
• If you decide to cancel without executing Quick Rec, move the cursor to the
• At this time, you can also turn off the blinking [REC TRACK SELECT] buttons to
5. Press the [TRACK] key
The display will show the TRACK screen TR View page. As you can see from the
display shown below, executing Quick Rec will turn input monitor on (I field=
for all tracks, and will mute (M field=
144
— Operation Guide
Input
patch
8
8
CANCEL button and press the [ENTER] key.
limit the number of recording tracks, or re-adjust the mix parameters and input
patch settings of each channel.
Mixer section
Input channels 1–8
Input channels 9–16
[F1] key.
) all tracks.
Recorder
Input
patch
Recorder section
Tracks 1–8
Tracks 9–16
)