Midi Sync Page; Make Settings Related To Midi Synchronization - Yamaha AW4416 Operation Manual

Make settings related to MIDI synchronization

[Function]
Make various settings for synchro-
nization operation.
[Key operation]
• [MIDI] key [F2] (MIDI Sync)
key
• Repeatedly press the [MIDI] key
until the screen shown at the
right appears.
[Mouse operation]
M button MIDI button
Sync tab
[Screen functions]
A
SYNC OUT
Select one of the following synchronization sig-
nals for output.
OFF
Synchronization signals will not be output.
MTC
MIDI Time Code will be transmitted from the
MTC OUT connector.
MIDI CLOCK
MIDI Clock will be transmitted from the MIDI
OUT connector or TO HOST connector.
MTC + MIDI CLK
Both MIDI Time Code (MTC OUT connector)
and MIDI Clock (MIDI OUT connector or TO
HOST connector) will be transmitted.
When using the AW4416 as the MIDI Clock
master, you must set MIDI OUT SEL. to
"MIDI OUT" in the MIDI screen MIDI Setup
page. ( P.39)
B
MTC SYNC
Specify whether the AW4416 will be the MTC
master (MASTER) or slave (SLAVE) when MTC is
used to synchronize an AW4416 song with the
operation of an external MIDI device.

MIDI Sync page

5
MIDI
1 2
If master is selected, MTC messages will be
transmitted from the MTC OUT connector in
synchronization with the progress of the song. If
slave is selected, the AW4416 song will follow
the MTC messages received at the MIDI IN con-
nector.
Tip!
The MTC frame rate is selected in the SONG
screen Setting page (
C
MMC (MIDI Machine Control)
When using MMC for remote control between
the AW4416 and an external MIDI device, this
setting specifies whether the AW4416 will be
the MMC master (MASTER) or slave (SLAVE).
If master is selected, operating the transport of
the AW4416 will cause the corresponding
MMC command to be transmitted from the
MIDI OUT connector or TO HOST connector.
If slave is selected, MMC commands sent from a
MIDI sequencer or other external device can be
used to remotely select or de-select recording
tracks and control transport operations on the
AW4416.
MIDI screen
3 4
6
P.2).
41
— Reference Guide