Patching To The Recorder Inputs - Yamaha AW4416 Operation Manual

Patching to the recorder inputs

When the AW4416 is in the default state, buses 1–8 are assigned respectively to
recorder inputs 1–8 and 9–16, but you can assign the direct signals from the
input channels as desired.
Here's how to assign the desired signals to recorder inputs 1–16.
1. Press the [SETUP] key
Patch IN page.
The RECORDER TRACK INPUT ASSIGN column will indicate the patched status
of recorder inputs 1–16.
Tip!
If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key to
switch the tabs, and then press the [F1] key.
2. Move the cursor to the recorder input whose patching you wish to
change, and use the [DATA/JOG] dial to select the signal that you wish
to assign.
The following types of signal can be assigned to each input.
Recorder inputs 1–16
BUS 1 – BUS 8
DIR 1 – DIR16
Mixer section
Buses 1–8
[F1] (Patch IN) key to access the SETUP screen
RECORDER
TRACK INPUT
ASSIGN column
Display
Recorder
input patch
Recorder section
8
8
Type of signal
Buses 1–8
Input channel direct out 1–16
Chapter8—Patching
Tracks 1–8
Tracks 9–16
135
— Operation Guide