Recorder Input Patching; Monitor Channels 1-16 - Yamaha AW4416 Operation Manual

Chapter1—Welcome to the world of the AW4416

Recorder input patching

This section assigns the signals that are input to tracks 1–16 of the recorder sec-
tion. The following types of signal can be selected.
STEREO
The stereo bus output signal that has passed through the stereo output channel.
BUS 1–8
The output signal of buses 1–8.
DIRECT OUT 1–16
The direct output signal of input channels 1–16.
Monitor channels 1–16
These are monaural channels that are assigned to the track 1–16 outputs of the
recorder section. According to the input monitor settings or the state of the trans-
port, they will input either the signals being input to tracks 1–16, or the playback
signals of tracks 1–16.
As an exception, the stereo track will be patched to monitor channels 1/2 when
the stereo track of that song is being played back, and the remainder of the moni-
tor channels 3–16 will be muted.
The structure of these channels is the same as that of the input channels, with the
exception that the direct output is fixed at a point immediately before the attenu-
ator.
16
RECORDER INPUT 1-16
INPUT
MONITOR
RECORDER
16
RECORDER
REPRO1-16
2
RECORDER
ST Trk L/R
26
— Operation Guide
8
BUS 1~8
16
CH DIRECT OUT1~16
2
STEREO
RECORDER MONI 1(...16)
METER
(FL Display)
METER
INSERT
ATT 4 BAND EQ
METER
RECORDER
(EQ)
DIRECT OUT
Mono in X 16
RECORDER INPUT 1~16
16
DITHER
METER METER
ON LEVEL
PAN
DY- INPUT
NAMICS DELAY
PRE/POST
METER
(Gain Reduction)
RECORDER
INPUT 1(...16)
PREFADER LISTEN/
AFTER PAN
SOLO
ON AUX
...