To Start The Engine - Triumph Daytona 675 Handbook

To Start the Engine

Check that the engine stop switch is
in the 'RUN' position.
Ensure the transmission
neutral.
Turn the ignition switch on.
NOTE
• When the ignition
switched on,
tachometer needle
quickly sweep from zero to
maximum and then return
to zero. The
warning lights
illuminate and will then go
off (except those
normally remain on until the
engine starts - see 'Warning
Lights' on page 39. It is not
necessary to wait for the
needle to return to zero
before starting the engine.
• In very cold conditions, part
open the throttle to aid cold
starting. Return it to the
closed position
engine has started.
Pull the clutch lever fully into the
handlebar.
Leaving the throttle fully closed,
push the starter button until the
engine starts.
How to Ride the Motorcycle
Never start the engine or run the
is in
engine in a confined area. Exhaust
fumes
cause loss of consciousness and
death within a short period of
time.
is
motorcycle in the open-air or in an
the
area with adequate ventilation.
will
instrument
Do not
will
continuously
5 seconds as the starter motor will
which
overheat
become
15 seconds
operation of the starter to allow for
cooling and recovery of battery
power.
Do not let the engine idle for long
periods
overheating
damage to the engine.
once the
Warning
are poisonous and can
Always operate your
Caution
operate the starter
for more than
and the battery
discharged. Wait
between each
as this may lead
which will cause
will
to
55