Disposal Of Used Engine Oil And Oil Filters; Oil Specification And Grade - Triumph Daytona 675 Handbook

Maintenance and Adjustment
Start the engine and allow it to idle
for a minimum of 30 seconds.
Caution
Raising the engine speed above
idle, before the oil reaches all
parts of the engine can cause
engine damage or seizure. Only
raise engine speed after running
the engine for 30 seconds to allow
the oil to circulate fully.
Caution
If the engine oil pressure is too
low, the low oil pressure warning
light will illuminate. If this light
stays on when the
running, stop the
immediately and investigate the
cause. Running the engine with
low oil pressure will cause engine
damage.
Ensure that the low oil pressure
warning light extinguishes shortly
after starting.
Turn off the ignition, check the oil
level using the method previously
described, and top-off to between
the minimum and maximum level
lines on the dipstick.
Install the lower
(Daytona 675 only).
76
Disposal of Used Engine Oil
and Oil Filters
To protect the environment, do not
pour oil on the ground, down sewers
or drains,
courses. Do not place used oil filters
in with general waste. If in doubt
contact your local authority.

Oil Specification and Grade

Triumph
injected engines are designed to use
10W/40 or 15W/50 semi or fully
synthetic motorcycle engine oil that
meets specification
higher) AND JASO MA.
Do not add any chemical additives to
the engine oil. The engine oil also
lubricates
engine is
additives could cause the clutch to
engine
slip.
Do not use mineral, vegetable, non-
detergent oil, castor based oils or
any oil
required specification. The use of
these oils may cause instant, severe
engine damage.
fairing
or into groundwater
high performance fuel
API SH
the clutch and any
not conforming to the
(or