Rear Seat/Seat Cover; Breaking In - Triumph Daytona 675 Handbook

General Information
To install the seat, engage the seat's
tongue under the fuel tank and press
down at the rear to engage in the
seat lock.
Warning
To prevent detachment of the seat
during riding, after fitting always
grasp the seat and pull firmly
upwards. If the seat
correctly secured it will detach
from the lock. A loose or detached
seat could cause loss of motorcycle
control and an accident.

Rear Seat/Seat Cover

Daytona 675 only
1
cdlp
1 Rear seat fastener
To remove the rear seat cover or
rear seat (where fitted): Remove the
fastener located beneath
padding. This will allow the rear
seat/seat cover to be slid forwards
for complete removal
motorcycle.
50
Breaking-In
process that occurs during the first
hours of a new vehicle's operation.
In particular, internal friction in the
engine
is not
components are new. Later on, when
continued operation of the engine
has ensured that the components
have 'bedded
friction will be greatly reduced.
A period of careful breaking-in will
ensure lower exhaust emissions, and
will optimize
economy and longevity of the engine
and other motorcycle components.
During
(800 kilometers):
• Do not use full throttle.
• Avoid high engine speeds at all
times.
• Avoid riding at one constant
engine speed, whether fast or
slow, for a long period of time.
• Avoid aggressive starts, stops,
and rapid accelerations, except
in an emergency.
• Do not ride at speeds greater
than 3/4 of maximum engine
speed.
From 500 to 1000 miles (800 to
1500 kilometers):
the
• Engine speed can gradually be
increased to the rev limit for
short periods.
from the
Breaking-
In is the
name
given
the
will be higher when
in', this internal
performance, fuel
the first 500 miles
to