To Stop The Engine; To Start The Engine - Triumph Speed Triple S Owner's Handbook Manual

How to Ride the Motorcycle

To Stop the Engine

2
1. Engine stop switch
2. START position
3. Neutral indicator light
4. ON position
5. Ignition switch
Close the throttle completely.
Select neutral.
Turn the ignition switch off.
Select first gear.
Support the motorcycle on a firm, level
surface with the side stand.
Lock the steering.
Caution
The engine should
stopped by turning the ignition switch
to the OFF position. The engine stop
switch is for emergency use only.
Do not leave the ignition switched on
with the engine stopped. Electrical
damage may result.
68
1

To Start the Engine

Check that the engine stop switch is in
the RUN position.
Make sure the transmission is in neutral.
Pull the clutch lever fully into the
handlebar.
Turn the ignition switch on.
Note:
• When the ignition is switched on, the
tachometer needle will quickly sweep
from zero to maximum and then
return to zero. The instrument
warning lights will illuminate and will
then go off (except those which
normally remain on until the engine
normally be
starts - see page 23. It is not
necessary to wait for the needle to
return to zero before starting the
engine.
Leaving the throttle fully closed, push
the starter button until the engine
starts.
Slowly release the clutch lever.
3
5 4
P