Table of Contents
Advertisement
Assembly...
W
A X M I N S T E R
W H I T E
Rubber Feet and Sanding Belt Table
Locate the four rubber feet (F); turn the belt and disc sander (A) on it's side and insert a rubber foot
into each of the four pre-drilled holes in the base plate (See fig 1). Stand the sander upright.
Fig 1
Insert the rubber foot into the pre-drilled
hole in the base plate
Locate the sanding belt table (D), M8 x 20mm lift and shift handle (G) and M8 washer (I). The sanding
belt table (D) has a machined cutout slot; slide the belt into the slot until the clamping bracket is flush
against the frame. Line up the machined slot in the bracket with the pre-drilled tappered hole in the
casting, using the M8 washer (I) and M8 x 20mm lift and shift handle (G). Clamp the table in position
(See figs 2-3 and 4).
NOTE: You my find it easier if you remove the lift and shift handle (G) and screw the clamping rod in
finger tight, then replace the handle (See fig 3)
Fig 3
I
Lightly screw the clamping rod in
until it is finger tight
!
NOTE: When tilting the table, it should be adjusted so that the gap between the belt and
the table is no larger than 1.5mm (1/16"). A gap greater than this could cause small workpieces
to slip down between the belt and table.
07
F
www.axminster.co.uk
D
Lower the sanding belt table (D) in position
Tighten the lift and shift handle to
clamp the table (D) in position
Fig 2
G
Fig 4
Advertisement
Table of Contents
