Table of Contents
Advertisement
CONNECT THE SANDER TO THE
MAINS SUPPLY
Remove all tools away for the machine, Switch on, wait
until the machine has reached full speed and check that
the belt is tracking properly. If not, switch off, wait for
the machine to come to a complete stop, disconnect
Dust Extraction
The dust extraction mouldings (h) have a 45mm outlets, (See figs 29-30) Insert a jubilee clip over the hose and insert it
over the outlet and clamp in place. Alternately, if you have a vacuum cleaner with the same diameter holes insert it over
the outlet as before, it should be a snug fit.
Fig 29.
Disc Sanding
the sander and go to page 9 for "Tracking the Belt".
Reconnect, switch on and check again. If everything is
fine, switch off and wait until the machine has come to a
complete stop.
Fig 30.
h
Belt Sanding
11
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY
h
Sanding Configurations
Angle Sanding
Setting Up
Advertisement
Table of Contents
