Avery Dennison ALX 720 User Manual page 34

Operators Manual
ALX 720
Error display:
If the display shows e.g. E__XX, the 720 (dispenser) has recognised an error. A
warning is shown by W_XX. As soon as the error has been corrected, you may erase
the message by pressing the key ENTER and you will get back to the status the
machine was in before the error was indicated.
Note: Data entered in the standard menu are not stored, if the 720 is switched off. If
you need to store data you have to use the extended menu. Please check if it is of
help for you using the product menu in your application.
Display Menu function
ON Labeller ready
OFF Label function suspend
POS label position on product
STOD Label stop position at the
dispensing edge
VELO Dispensing speed
STAD delay time before labelling starts
BLOW apply time
INIT Initialisation of label material
(CONT and LPIT are measured
according to label size)
Dispenser active ___________________________________________________ ON
The dispenser is able to dispense labels.
Dispenser stopped ________________________________________________ OFF
The dispenser function is stopped. Single labels could be dispensed with the FEED key.
Material initialisation _______________________________________________ INIT
A new initialisation of material is necessary. Pressing the FEED key will start the initialisation.
Label position ____________________________________________________POS
The position of the label can be changed by the parameter POS while the machine is in
operation. The display is presented in 1/10 mm and means the distance between product
sensor and labelling position of the product. The display value 0500 would mean 50.0 mm. By
pressing the key PRIOR the value is increased, i.e. the label is put on later. By pressing the key
NEXT FUNCTION the value is decreased and the label is put on earlier.
4/09
Function data value
Up to ... 999.9 mm
Depends on machine configuration.
See description
0.2 .. 30.0 m/min
0,1 ... 999,9 ms
0,1 ... 999,9 ms
Appears after E__0, E__1 and Power
on + FEED key depressed, or if the
values of CONT and LPIT are
changed
Page 34 Operation