12/08 Rev. 5.01-01
Mounting the Printer
Unpacking the AP 7.t
1. Lift off the lid of the shipping box [1].
2. Take out the plastic bag containing the
accessories [1B].
3. Lift off the styrofoam support [1A].
4. Part the plastic cover [2].
5. Grab the printer from underneath and lift it
out. The material feed slot in the back wall
of the printer [3A] can be used as a
handle.
CAUTION! - Do not lift the printer by
the front cover [3B]. The front cover is
a movable part not designed for
handling stress.
6. Place the printer on a level surface in its
usual operating position (rubber feet [3C]
at the bottom).
The original packaging should always
be used for transporting the printer!
USER MANUAL
AP 7.t
[1]
Shipping box without lid:
A Styrofoam support
B Accessories
[2]
Part the plastic cover...
B
C
[3]
... and lift the printer out of the box.
A Back wall of printer (not visible)
B Front cover (do not use for lifting)
C Rubber feet
Commissioning & Operation
A
B
2
A