Remote Control - Dimplex DFB8842 Owner's Manual

Remote Control

The remote control has a range of approximately 50 feet (15.25 m),
it does not have to be pointed at the fireplace and can pass through
most obstacles (including walls). It is supplied with 243 independent
frequencies to prevent interference with other units.
Battery Installation
1. Depress tab on the battery cover on
the back of the remote transmitter
and remove battery cover.
2. Install two (2) AAA batteries into the
remote control (included).
3. Ensure child lock is in the "unlocked"
position (Figure 5).
4. Replace the battery cover.
!
NOTE: When the "BAT" symbol is present on the remote control it
is recommended to replace the batteries promptly, to maintain full
functionality of the remote/fireplace. The remote transmitter has a
battery backup time of only several hours.
Remote Control Initialization
1. Plug power cord into a 120 Volt wall outlet.
2. Ensure the Main On/Off Switch located in the switch box on the
fireplace in the lower right hand corner (Figure 4A) is in the ON
position.
3. Set the 3 Position Manual Control Switch (Figure 4B) to the
Remote position (right position).
4. Press and hold the Initialization Button (Figure 4C) on the unit.
5. While holding the Initialization Button, press the Flame/heat On/
Off button or the Purifire™ On/Off button on the remote control
transmitter.
6. Release the Initialization Button on the unit.
7. Press the Flame/heat On/Off button to turn the Flame/heat
function On or press the Purifire™ On/Off button to turn the
Purifire™ function On.
Figure 5
Batteries
Child Lock
10