CAUTION: If you need to continuously reset the heater, Press H button to turn fireplace on. Press J to raise unplug the unit and call Dimplex North America Limited thermostat, or I to lower the thermostat. Press both J and I to at 1-888-346-7539.
Page 4
Figure 3 - Remote Control Functions and off to maintain the desired set temperature. Disable Heat If desired, depending on the season, the heater on the unit can be disabled. The unit will operate in the same fashion, with remainder of the controls. To Disable - Press J and O at the same time.
Maintenance Figure 6 WARNINg: Disconnect power before attempting any Ember Bed maintenance or cleaning to reduce the risk of fire, electric Back Ledge shock or damage to persons. Light Bulb Replacement CAUTION: Allow at least five (5) minutes for light bulbs and heater to cool off before touching bulbs to avoid Rear accidental burning of skin.
Purifire™ Filter Figure 7 The Purifire™ filter supplied in your fireplace is reusable and washable. The filter should be cleaned or replaced on average once a year. To clean the filter gently tap filter Purifire™ on a hard surface to dislodge any loose dirt or debris, and Filter then clean with water.
Disconnect LED harness (only required on DF3015 unit). Slide firebox out of mantel. Loosen, but do not remove, the two (2) Philips screws that clamp the Partially Reflective Glass in place, and Lay unit on it’s back for safe removal of Front Glass.
Lay unit on it’s back for safe removal of Front Glass. Disconnect LED harness (only required on DF3015 unit). Remove four (4) Phillips screws from right side of trim Set Log Set Assembly in front of firebox.
! NOTE: Log Set Assembly fits tightly into firebox, some force may be necessary to remove. Disconnect LED harness (only required on DF3015 unit). Set Log Set Assembly in front of firebox. Loosen, but do not remove, the two (2) Philips screws...
10 minutes for light bulbs and heating element to Disconnect LED harness (only required on DF3015 unit). cool off to avoid accidental burning of skin. Set Log Set Assembly in front of firebox.
Reflective Glass (Figure 9). Push the Partially Reflective Glass out from behind to ii) Properly orient replacement Cutout and attach to clear the frame and remove. Heater Assembly with screw previously removed. Remove the 14 screws that attach the top panel to the iii) Disconnect the two (2) wires from the defective firebox.
① Ember Bed or plastic grate. ! NOTE: Log Set Assembly fits tightly into firebox, some force may be necessary to remove. Disconnect LED harness (only required on DF3015 unit). Set Log Set Assembly in front of firebox. Heater ⑥...
Page 17
Figure 18 3000880100 3000300200 Power Cord Antenna wire ① ① ② ② Remote Control Receiver ① Black wire with smooth sides (from narrow blade of plug) leading to On/Off Switch ② Black wire with ridged sides (from wide blade of plug) leading to JP15 (3000300200) JP9 (3000880100) terminal of Remote Control Receiver...
Troubleshooting guide PROBLEM CAUSE SOLUTION general Circuit breaker trips or fuse blows Short in unit wiring. Trace wiring in unit. when unit is turned on Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit.
Page 19
PROBLEM CAUSE SOLUTION Heater Heater is not turning off (Manually) Improper operation Refer to Operation Section Defective Remote Switchboard Replace Remote Switchboard Defective Remote Control Receiver Replace Remote Control Receiver. Initialize Remote Control and Remote Control Receiver. Heater is not turning on (Manually) Improper operation Refer to Operation Section Heater has been disabled...
Need help?
Do you have a question about the DF3015 and is the answer not in the manual?
Questions and answers