Operation - Dimplex DFB8842 Owner's Manual

Operation

Electric Fireplace Manual
Controls
The manual controls for the fireplace
are located in the lower right hand
corner (Figure 4).
A. Main On/Off Switch
Supplies power to the 3 position
manual control switch.
B. 3 Position Manual Control Switch
Remote (right position): The unit is operated with the remote
control.
Flame (center position): The flame effect is turned ON.
Flame & Heat (left position): The flame effect and heater are
turned ON simultaneously. When the manual control is in the
Flame & Heat position the heater does not run on the remote
operated thermostat.
C. Initialization Button
Used to synchronize remote control.
!
NOTE: When the manual control switch is in the Flame and Flame
& Heat positions, the fireplace unit will not operate with the remote
control.
Resetting The Temperature Cutoff Switch
The heater is protected with a safety device to prevent overheating.
Should the heater overheat, an automatic cut out will turn the heater
off and it will not come back on without being reset. It can be reset
by switching the ON/OFF Switch to OFF and waiting five (5) minutes
before switching the unit back on.
CAUTION: If you need to continuously reset the heater, unplug
the unit and call Dimplex North America limited at 1-888-346-7539.
have the product Model and Serial Numbers ready when calling.
Figure 4
A
B
9
C