Table of Contents
Advertisement
Remote control
The fireplace is supplied with a remote control.
Operating Instructions using REMOTE CONTROL - See Figure 17
Icon
Display
Funtion
"FIRE" /
A
"ST.BY"
B
"TIMR"
C
"SNSR"
"ON"
Heat Mode
D
"OFF"
Heat Mode
E
"15ST"
F
"32ST"
G
"-F1-"
Brightness
H
"-F6-"
Brightness
I
"VOL1"
J
"VOL6"
K
"AMB1"
L
"LGT1"
Selection
WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN
•
Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns
and potential perforation of the oesophagus.
•
If you think batteries might have been swallowed or placed inside any part of the body seek
immediate medical attention
•
Examine devices and make sure the battery compartment is correctly secured, e.g. that the
screw or other mechanical fastener is tightened. Do not use if the compartment is not secure.
•
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
Description
Press Once to turn the product on. ("ON")
Press a second time to put the product into standby. ("ST.BY" is shown, then "." is displayed
Power /
to indicate standby.)
Standby
(When returning from 'STANDBY' mode the product will return to previous settings unless the
product has been unplugged, in which case it will reset to factory settings)
This Button changes the timer setting. This can be set between 0.5 Hrs and 8.0Hrs in incre-
Timer
ments of 0.5 hrs. ("0.5Hr" to "8.0Hr + OFF") Each Button press will increase timer setting by
0.5hrs.
Cycle
This Button cycles through the SmartSense settings. Display will read; "MIN", "MAX" or
"OFF".
Smart-
"MIN" turns product off 0.5 hour after last movement detected in room.
Sense
Cycle
"MAX" turns product off 3 hour after last movement detected in room.
"OFF" - SmartSense is turned off
First Button press activates the heat. Display reads "ON - XXST - XX
Second button press deactivaes the heat. Display shows "OFF"
Press Once to display current Set Temperature.
Temp
Press multiple times to lower the heater temperature in 1
Down
temperature that can be set is 15
Press Once to display current Set Temperature.
Temp Up
Press multiple times to increase the heater temperature in 1
temperature that can be set is 32
Flame
Press Once to display current flame brightness setting.
Press to reduce the flame brightness setting. Range is from "-F1-" to "-F6-" and "OFF".
Down
Flame
Press Once to display current flame brightness setting.
Press to increase the flame brightness setting. Range is "OFF", then "-F1-" to "-F6-"
Up
Press Once to display
Volume
Down
Press to reduce the volume setting. Range is "OFF", then "VOL1" to "VOL6".
Press Once to display current volume setting.
Volume
Up
Press to increase
Press once to display current Ambient Setting. Subsequent presses will cycle trhough the
Ambient
settings. Range is from "AMB1" to "AMB7". "AMB8" will also display once it is activated via
Cycle
the app.
Light
Press once to show all toplights and fuelbed and flame colour lights ON. Subsequent
presses cycle through ON/OFF settings for each of these lights. "ON" to "LGT4"
Button
C.
0
C.
0
current volume setting.
the volume setting. Range is "OFF", then "VOL1" to "VOL6".
11
C"
0
C increments. The lowest
0
C increments. The highest
0
Advertisement
Table of Contents
