Remote Control; Maintenance; General Tips; Changing Lamps - Dimplex Pro ENG56-400 Installation Manual

Adaptive Start
The built-in electronics in this appliance have a learning function with regards to how long it takes to heat up a room. Having
learnt how quickly it can heat up your room, the appliance is able to turn on at just the right time in order to get the room
up to a comfortable temperature when you want it. For example, if you get up at 7am, you would normally have to guess
when to turn the heating on in order for it to pre-heat the room in time. Depending on how cold it is outside, this could mean
the room is still cold when you have to get out of bed, or mean that its been warm for half an hour before it needed to be.
Adaptive Start means that if you select 21°C at 7am, the heater will turn on exactly when it needs to in order to meet this
target, running for shorter periods of time when the weather is mild, and ensuring the room is nice and warm in the winter.
The Adaptive Start function will automatically activate when you use the Timer Mode.

Remote Control

1
Display Screen
2
'Menu' Button
3
'Back' Button
4
'Advance' Button
5
'Up and Down' Arrows
6
'Enter' Button

Maintenance

GENERAL TIPS

Only use filtered tap water in this appliance.
Always ensure that the appliance is sitting on a level surface.
If you intend not using the appliance for longer than a week, remove and empty the sump and water tank.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
The appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under 'Changing lamps'.
FILLING THE WATER TANK
When the water tank is empty, the flame and smoke effect shuts off and you will hear 2 audible beeps, follow these steps.
1. Press Switch 'A' to (0) (Fig. 10)
2. Gently lift out the fuelbed and carefully set aside.
3. Remove the water tank by lifting upwards and outwards.
4. Place the water tank in sink and remove cap, Anti-clockwise to open. (Fig. 7)
5. Fill tank with filtered tap water only. This is necessary to prolong the life of the flame and smoke producing unit.
The water should be filtered through a conventional domestic water filter unit and the filter should be replaced regularly.
6. Screw the cap back on, do not over tighten.
7. Return the tank to the sump, with the tank cap facing down and the flat side of the tank facing outward. (Fig. 8)
8. Gently place the fuelbed back into position. (Fig. 9)
9. Press Switch 'A' to 'ON' (I) position (Fig. 10)

CHANGING LAMPS

If the flame and smoke effect appears grey or colourless it may be that one or more lamps have failed.
You can check for lamp failure as follows.
1. Leaving the flame effect on, lift out the fuelbed and water tank.
2. It should be possible to view the lamps with the nozzle in place and observe which one needs to be changed.
1
2
3
6
7
4
5