Maintenance - Dimplex DFB8842 Owner's Manual

4. Press the Initialization button on the unit (Figure 4C).
5. Press the
H. Flame & Heat On/Off
Your remote will now have a different frequency communicating with
the fireplace.

Maintenance

WARNING: Disconnect power before attempting any maintenance
or cleaning to reduce the risk of fire, electric shock or damage to
persons.
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs and heater to cool off
before touching bulbs to avoid accidental burning of skin.
light bulbs need to be replaced when you notice a dark section of
the flame. There are three (3)
flames and embers, and two (2) bulbs above the log that illuminate the
log exterior.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce the number
of times you need to open the unit to replace light bulbs. Care must be
taken when removing the Log Set as the Log Set contains LED's and
wires.
Lower Light Bulb Requirements
Quantity of three (3) clear chandelier or candelabra bulbs with an E-12
(small) socket base, 60 Watt rating. Example: GE 60BC or Philips
60CTC.
Do not exceed 60 Watts per bulb.
To access the lower light bulb area:
1. Slide fireplace out of mantel.
2. Remove four (4) Phillips screws from right side of trim (Figure 7).
3. Remove trim.
button on the remote.
under the Log Set, which generate the
14