Dimplex DFB8842 Owner's Manual page 16

edge of the Ember Bed until the rear tab snaps into place under the
Mirror (Figure 8).
!
NOTE: Ensure the log Set Assembly is installed tightly under the
back ledge to prevent light leakage.
10. Slide front glass back into position and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with an E-12
(small) socket base, 15 Watt rating.
Do not exceed 15 Watts per bulb.
To access the upper light bulb area:
1. Slide fireplace out of mantel.
2. Remove four (4) Phillips screws from right side of trim (Figure 7).
3. Remove trim.
4. Slide glass to the right side of the fireplace to remove (Figure 7).
5. Remove Upper light Bracket (Figure 7).
6. Upper bulbs are located in the upper left and upper right corners of
the fireplace.
7. Unscrew bulbs counter clockwise.
8. Insert new bulbs and screw in clockwise.
9. Re-install Upper light Bracket.
10. Slide front glass back into position and attach trim.
Purifire™ Filter
The Purifire™ filter supplied in your fireplace is reusable and
washable. The filter should be cleaned or replaced on average once a
year. To clean the filter gently tap filter on a hard surface to dislodge
any loose dirt or debris, and then clean with water. No soap or
cleaning products are recommended. The filter size is 20 x 10 x 1
inches, rated at MERV 10.
To replace filter:
1. Remove fireplace from mantel.
16