Operation; Maintenance; Replacing The Battery; Cleaning - Visonic Fully supervised wireless accessories Accessories Manual

When exiting "
ZONES / DEVICES
number of devices that need to be updated, as follows: DEV UPDATING NNN.
For detailed instructions on ADDING DEVICES, DELETING DEVICES and
MODIFYING DEVICES see the PowerMax10-G2 Installer Guide.

5. OPERATION

Initiate Panic Alarm:
Press ARM AWAY and
ARM HOME together for 2
seconds.
Arming Latchkey: Press
ARM AWAY/HOME twice.
Arm AWAY/HOME: Press
AWAY or HOME button
once.
Status: Press ' ' button
once.

6. MAINTENANCE

6.1 Replacing the Battery

A replacement 3V battery, CR-2032, is available from
hardware and electrical supply stores. Replace the battery
as shown in Figure 3.
Caution! Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to the
manufacturer's instructions
Button pad (Make sure that
it remains in its place)
Using the screwdriver, push out the battery
from its holder and install new battery
(polarity "+" as shown).
2
LED
indicator
Test the unit by momentarily pressing
one of the Transmit buttons - the LED
should light. Put back the cover and
re-attach it with the screw.
Figure 3 - Battery Replacement

6.2 Cleaning

The keyfob may get dirty if touched with greasy fingers.
Clean it only with a soft cloth or sponge moistened lightly
with a mixture of water and mild detergent, and wipe it dry
immediately.
The use of abrasives of any kind is strictly forbidden.
Also never use solvents such as kerosene, acetone
or thinner.
D-302758
" menu the PowerMax10-G2 system displays the
ARM
"AWAY"
ARM
"HOME"
Figure 2: Operation
Remove backside screw
1
and open the cover.
Battery
holder
Battery
3

7. TESTING A NEW UNIT

Since the KF-234 PG2 is supplied with the battery already
LED
installed, the unit is practically ready to be tested.
A. Stand 3 m (10 ft) away from a target control panel (or
DISARM
wireless control panel) and press the ARM AWAY
button (see Fig. 2). Verify that the red LED lights upon
AUX
transmission and that the green LED lights upon
acknowledgement from the PowerMax10-G2.
B. Make sure that the control panel responds as
programmed and as stated in the control panel's
instruction manual.

8. MISCELLANEOUS COMMENTS

8.1 Product Limitations

Visonic Ltd. wireless systems are very reliable and are
tested to high standards. However, due to their low
transmitting power and limited range (required by FCC and
other regulatory authorities), there are some limitations to
be considered:
A. Control panels may be blocked by radio signals occurring
on or near their operating frequencies, regardless of the
code selected.
B. Wireless equipment should be tested regularly to
determine whether there are sources of interference
and to protect against faults.
KF-234 PG2
3