Smoke Detector Test; Diagnostics Test - Visonic Fully supervised wireless accessories Accessories Manual

SMD-426, SMD-427
The PowerMax10-G2 display will read [Fire Siren].
6.
Press the
I OK
The PowerMax10-G2 display will read [enable
7.
Press the
"disable", for example, "disable".
8.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [Fire Siren].
9.
Press the
The PowerMax10-G2 display will read [Gas / CO Siren].
10.
Press the
I OK
The PowerMax10-G2 display will read [enable
11.
Press the
"disable", for example, "disable".
12.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [Gas / CO Siren].
13.
Press the
The PowerMax10-G2 display will read [Flood Siren].
14.
Press the
I OK
The PowerMax10-G2 display will read [enable
15.
Press the
"disable", for example, "disable".
16.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [Flood Siren].
When exiting "
ZONES / DEVICES
number of devices that need to be updated, as follows: DEV UPDATING NNN.
For detailed instructions on ADDING DEVICES, DELETING DEVICES and
MODIFYING DEVICES see the PowerMax10-G2 Installer Guide.

6. SMOKE DETECTOR TEST

Enter the test mode by pressing the test button for 2
seconds and release it. In this mode, the detector will test
smoke, heat and battery functions. If all functions are
good, the red LED lights 0.5s, off 0.5s, the yellow LED
lights 0.5s, off 0.5s followed by a loud 3-beep alarm and
the red LED flashes simultaneously. Otherwise, the
detector produces the warning signals as detailed in
Table 1.
If the detector is in any diagnostics mode, the detector
performs the diagnostics test as described in section 6.1.
12
button.
or button to select between "enable" and
button.
button.
or button to select between "enable" and
button.
button.
or button to select between "enable" and
" menu the PowerMax10-G2 system displays the
].
].
].

6.1 Diagnostics Test

Caution! The diagnostics test cannot be performed while
tamper is in "open" state.
A. The detector performs a LED communication test.
B. When the LED lights orange (red and green), this
indicates correct operation of the LEDs.
C. The detector now performs the link quality test.
Note: If the detector is not in local diagnostics or
installer diagnostics mode, the detector will not perform
the link quality test.
Fire Siren
I OK
enable
or
disable
I OK
disable
Fire Siren
Gas / CO Siren
I OK
enable
or
disable
I OK
disable
Gas / CO Siren
Flood Siren
I OK
enable
or
disable
I OK
disable
Flood Siren
D-302758