Repeaters (Rp-600; Introduction; Specifications; Installation - Visonic Fully supervised wireless accessories Accessories Manual

REPEATERS (RP-600 PG2)
Wireless Repeater for PowerG Communications

1. INTRODUCTION

The RP-600 PG2 is a range
extender designed to relay digital
data between
PowerMax10-G2 Devices and a
PowerMax10-G2 Control
Repeater links are required when
the Control Panel is beyond the
range of at least some of the
devices and is therefore incapable
of receiving transmissions directly
(see Figure 2).

2. SPECIFICATIONS

Frequency Band (MHz): Europe 433, 868, USA: 915
Modulation Type: FSK (Frequency Shift Key).
Antenna: Built-in antenna
Communication Protocol: PowerG II
AC Power Supply : AC to AC adaptor.
120 VAC, 60 Hz / 9 VAC, 0.35 A min. (in the U.S.A.)
230 VAC, 50 Hz / 9 VAC, 0.35 A min.
Backup Battery: 4.8-Volt 1300 mAh NiMH rechargeable.
Note: Dispose of used batteries according to the
manufacturer's instructions.
2
1
D-302758
wireless
Panel.
Figure 1:
External View
(*)
AC to AC
adaptor
Figure 2 - Installation
Current drain at 5.7 VDC
Frequency (MHz)
Battery Backup Duration (with fully charged 1300 mA/h
battery) 48 hours:
LED indicator: Green LED lights when AC power on.
Compliance with Standards:
Europe: EN 50131-1, EN 50130-5, EN 50131-6, EN
301489, EN 50130-4, EN 300 220
USA: (FCC) CFR47 Part 15
Canada: RSS210
Operating Temperature: 0°C to 49°C (32°F to 120°F).
Dimensions (H x W x D): 161x161x50mm (6-7/16 x 6-
7/16 x 1-3/4 in)
Weight: (with battery): 470g (16.5 oz.)

3. INSTALLATION

3.1 Repeater's Location Selection

A. In a repeater setup, install the repeater where good
communication is assured with the target receiver and with
the transmitters deployed in the repeater's coverage area.
B. Mount the repeater as high as possible above the floor
and well away from metal chimneys, large metal
cabinets, metal doors and reinforced concrete walls, all
of which may reduce the communication range.
C. Make sure that the location you have selected is near
an electrical outlet.
3
5
.
RP-600 PG2
433 868
100 mA 100 mA 100 mA
4
For back
tamper screw
6
915
19