Installation; Enrollment - Visonic Fully supervised wireless accessories Accessories Manual

Dimensions (LxWxD): 295x186x63mm (11-5/8 x 7-5/16 x
2-1/2 in)
Color: White (with red, blue, amber or transparent lens)
Operating Temperature: -33°C to 70°C (-27.4°F to
158°F), RH humidity 75%.
Weight (including battery): 970g (34 oz)
Note: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's
authority to operate the equipment.
Interference Prevention
This device complies with FCC Rules Part 15. Operation is
subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference that may be received or that may cause
undesired operation.

3. INSTALLATION

1 2
Open Using Philips screw-
plastic cover driver, remove screw
screw and remove cover.
A B
7
Release catch (A) and open battery cover (B)

4. ENROLLMENT

Refer to the PowerMax10-G2 Installer Guide for the device enrollment procedure.
D-302758
For
tamper
3
Optional step only:
Hang back unit with a screw on
mounting surface to make the next
step (drilling marking) easier.
Self-test button
Enroll button
Figure 3: Installation
The digital circuit of this device has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in
residential installations. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there
is no guarantee that interference will not occur in a particular
installation. If this device does cause such interference, which
can be verified by turning the device off and on, the user is
encouraged to eliminate the interference by one or more of
the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from
the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
Changes or modifications not expressly approved by Visonic
Ltd. could void the user's authority to operate the equipment.
4
Mark for driling
Drill 5 holes
Battery connector
Optional second
battery and
its connector
8
Connect battery / optional battery and 9VAC
power to the proper connectors and set the
optional jumpers as desired
SR-730 PG2
5 6
Fasten with 5 screws
Note: There are MCS-730 PC II model
variations that are supplied with battery only,
or, with battery and AC adapter.
Siren rear side
220/110 VAC
9VAC
9VAC
Note: When external
power is used, set the
AC Enable (ON)/
Disable(OFF) jumper
to Enable position
(see step 8)
23