Modify Device Settings - Visonic Fully supervised wireless accessories Accessories Manual

4. MODIFY DEVICE SETTINGS

This section describes how to configure the parameters of the PIR detector from the PowerMax10-G2 control panel.
To Modify the PIR Detector Device Settings
Refer to the PowerMax10-G2 Installer Guide and perform the procedure for Adding A Wireless Device (section 4.4.2), or,
Modifying a Device (section 4.4.5). Then continue below to modify the device settings.
1.
When the PowerMax10-G2 display reads [DEV SETTINGS], press
The PowerMax10-G2 display will read [Alarm LED].
2.
Press the
I OK
The PowerMax10-G2 display will read [LED ON
3.
Press the
for example, "LED OFF".
4.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [Alarm LED].
5.
Press the
The PowerMax10-G2 display will read [Event counter].
6.
Press the
I OK
The PowerMax10-G2 display will read [LOW sensitive
7.
Press the
"HIGH sensitive", for example, "HIGH sensitive".
8.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [Event counter].
9.
Press the
The PowerMax10-G2 display will read [DISARM Activity].
10.
Press the
I OK
The PowerMax10-G2 display will read [ NOT Active
11.
Press the
"YES – no delay", "YES + 5s delay", "YES + 15s delay", "YES + 30s
delay", "YES + 1m delay", "YES + 2m delay", "YES + 5m delay", "YES +
10m delay", "YES + 20m delay" and "YES + 60m delay", for example, "YES –
no delay".
12.
Press to confirm the selection.
I OK
The PowerMax10-G2 display will revert to [DISARM ACTIVITY].
When exiting "
ZONES / DEVICES
number of devices that need to be updated, as follows: DEV UPDATING NNN.
For detailed instructions on ADDING DEVICES, DELETING DEVICES and
MODIFYING DEVICES see the PowerMax10-G2 Installer Guide.
D-302758
button.
or button to select between "LED ON" and "LED OFF",
button.
button.
or button to select between "LOW sensitive" and
button.
button.
or button repeatedly to select between " NOT Active ",
" menu the PowerMax10-G2 system displays the
NEXT PG2, NEXT-K9 PG2
I OK
].
].
].
.
Event counter
LOW sensitive
HIGH sensitive
HIGH sensitive
Event counter
DISARM Activity
NOT Active
YES – no delay
YES – no delay
DISARM ACTIVITY
I OK
Alarm LED
I OK
LED ON
or
LED OFF
I OK
LED OFF
Alarm LED
I OK
or
I OK
I OK
or
I OK
5