Download Print this page

HP PROCURVE 2910AL Configuration Manual: Current Mld Configuration

Ipv6.
Hide thumbs

Advertisement

Current MLD Configuration

Syntax: show ipv6 mld config
Displays current global MLD configuration for all MLD-
enabled VLANS on the switch.
show ipv6 vlan <vid> config
Displays current MLD configuration for the specified VLAN,
including per-port configuration information.
vid—VLAN ID
For example, the general form of the command might look like this:
ProCurve# show ipv6 mld config
MLD Service Config
Control unknown multicast
Forced fast leave timeout
VLAN ID VLAN NAME
------- --------------- ----------- ---------------
8
VLAN8
9
VLAN9
Figure 7-6. Example of a Global MLD Configuration
The following information, for all MLD-enabled VLANs, is shown:
Control unknown multicast: If this is set to YES, any IPv6 multicast
packets that are not joined by an MLD host will be sent only to ports that
have detected a multicast router or ports that are administratively for­
warded. If this is set to NO (or if MLD snooping is disabled), unjoined IPv6
multicast packets will be flooded out all ports in the VLAN.
Forced fast leave timeout: the interval between an address specific query
and a forced fast leave (assuming no response), in tenths of seconds
For each VLAN that has MLD enabled:
VLAN ID and name
whether MLD is enabled on the VLAN (default NO, but the VLAN will
not show up on this list unless MLD is enabled)
whether the switch can act as querier for the VLAN (default YES)
Multicast Listener Discovery (MLD) Snooping
Displaying MLD Status and Configuration
[Yes] : Yes
[4] : 4
MLD Enabled Querier Allowed
Yes
Yes
Yes
Yes
7-15

Advertisement

Chapters

Troubleshooting

   Related Manuals for HP PROCURVE 2910AL

Comments to this Manuals

Symbols: 0
Latest comments: