Configuring Debug Destinations - HP PROCURVE 2910AL Configuration Manual

IPv6 Diagnostic and Troubleshooting
Debug/Syslog for IPv6
Syntax:. [no] debug < debug-type > (Continued)

Configuring Debug Destinations

A Debug/Syslog destination device can be a Syslog server (up to six maximum)
and/or a console session:
■
8-14
ip [ rip < database | event | trigger >
Configures specified IPv4 RIP message types to be sent to
configured debug destinations:
database— Database changes
event— RIP events
trigger— Trigger messages
ipv6
Configures messages for IPv6 DHCPv6 client and neighbor
discovery events to be sent to configured debug destina­
tions.
ipv6 [ dhcpv6-client <events | packets> | nd ]
Configures one of the following IPv6 message types to be
sent to configured debug destinations:
dhcpv6-clients events — DHCPv6 client events
dhcpv6-clients packets — Statistics on DHCPv6 packets
transmitted on a switch configured as a DHCPv6 client
nd— Events during IPv6 neighbor discovery
lldp
Configures all LLDP message types to be sent to configured
debug destinations.
wireless-services
Configures messages about the operation of wireless-ser­
vices modules to be sent to configured debug destinations.
Use the debug destination < logging | session | buffer > command to enable
(and disable) Syslog messaging on a Syslog server or to a CLI session for
the debug message types configured with the debug and logging com­
mands (see "Configuring Debug and Event Log Messaging" on page 8-12):
debug destination logging enables the configured debug message types
•
to be sent to Syslog servers configured with the logging command.
• debug destination session enables the configured debug message types
to be sent to the CLI session that executed this command. The session
can be on any one terminal emulation device with serial, Telnet, or
SSH access to the CLI at the Manager level prompt.