HP PROCURVE 2910AL Configuration Manual page 90

IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
For example, figure 4-1 shows the output on a switch having IPv6 enabled on
one VLAN.
4-22
Address Origin:
Autoconfig: The address was configured using stateless
■
address autoconfiguration (SLAAC). In this case, the
device identifier for global unicast addresses copied from
the current link-local unicast address.
DHCP: The address was assigned by a DHCPv6 server. Note
■
that addresses having a DHCP origin are listed with a 128­
bit prefix length.
Manual: The address was statically configured on the
■
VLAN.
IPv6 Address/Prefix Length: Lists each IPv6 address and
■
prefix length configured on the indicated VLAN.
Address Status:
Tentative: DAD has not yet confirmed the address as
■
unique, and is not usable for sending and receiving traffic.
Preferred: The address has been confirmed as unique by
■
DAD, and usable for sending and receiving traffic. The
Expiry time shown for this address by the show ipv6 vlan <
vid > command output is the preferred lifetime assigned to
the address. (Refer to "Address Lifetimes" on page xxx.)
Deprecated: The preferred lifetime for the address has been
■
exceeded, but there is time remaining in the valid lifetime.
Duplicate: Indicates a statically configured IPv6 address
■
that is a duplicate of another IPv6 address that already
exists on another device belonging to the same VLAN
interface. A duplicate address is not used.