View The Current Ipv6 Addressing Configuration - HP PROCURVE 2910AL Configuration Manual

View the Current IPv6 Addressing
Configuration
Use these commands to view the current status of the IPv6 configuration on
the switch.
Syntax: show ipv6
Lists the current, global IPv6 settings and per-VLAN IPv6
addressing on the switch.
IPv6 Routing: For software release K.13.01, this setting is
always Disabled. This is a global setting, and is not configured
per-VLAN. (Refer to "Router Access and Default Router Selec­
tion" on page 4-27.)
Default Gateway: Lists the IPv4 default gateway, if any, config­
ured on the switch. This is a globally configured router
gateway address, and is not configured per-VLAN.
ND DAD: Indicates whether DAD is enabled (the default) or
disabled. Using ipv6 nd dad-attempts 0 disables neighbor
discovery. (Refer to "Duplicate Address Detection (DAD)" on
page 4-18.)
DAD Attempts: Indicates the number of neighbor solicitations
the switch transmits per-address for duplicate (IPv6) address
detection. Implemented when a new address is configured or
when an interface with configured addresses comes up (such
as after a reboot). The default setting is 3, and the range is 0
- 600. A setting of "0" disables duplicate address detection.
(Refer to "Duplicate Address Detection (DAD)" on page 4-18.)
VLAN Name: Lists the name of a VLAN statically configured on
the switch.
IPv6 Status: For the indicated VLAN, indicates whether IPv6 is
disabled (the default) or enabled. (Refer to "Configuring IPv6
Addressing" on page 4-5.)
IPv6 Addressing Configuration

View the Current IPv6 Addressing Configuration

4-21