Configuring The Querier; Configuring Fast Leave - HP PROCURVE 2910AL Configuration Manual

Multicast Listener Discovery (MLD) Snooping
Configuring MLD

Configuring the Querier

Syntax: [no] ipv6 mld querier
For example, to disable the switch from acting as querier on VLAN 8:
ProCurve(vlan-8)# no ipv6 mld querier
To enable the switch to act as querier on VLAN 8:
ProCurve(vlan-8)# ipv6 mld querier

Configuring Fast Leave

Syntax: [no] ipv6 mld fastleave <port-list>
7-10
Note: This command must be issued in a VLAN context.
This command enables the switch to act as querier on a VLAN.
The [no] form of the command disables the switch from acting
as querier on a VLAN.
The querier function is enabled by default. If another switch
or a multicast router is acting as the MLD querier on the VLAN,
this switch will defer to that device. If an acting querier stops
performing the querier function, all querier-enabled switches
and multicast routers on the VLAN will enter an election to
determine the next device to act as querier.
Note: This command must be issued in a VLAN context.
This command enables the fast leave function on the specified
ports in a VLAN.
The [no] form of the command disables the fast leave function
on the specified ports in a VLAN.
The fast leave function is enabled by default.