Manual Selection; The Selection Parameter Field; Working With Regions In The Sample Editor - Emagic Logic fun User Manual

Chapter 14
The Sample Editor

Manual Selection

To select any section of the audio file with the mouse, click-
hold at the beginning or end of the desired area, and move the
mouse to the right or to the left.
Changing Selection Borders
The left or right border of an existing selection can be changed
by holding down the
point. Whether the start or end point is changed, depends on
whether the point clicked was closer to the beginning, or end of
the selection.
Shifting the Selected Area
By holding down the
dragging, the selected are can be shifted left or right, without
chaging its length.

The Selection Parameter Field

The Seection Parameter fiels (2) displays the position and
length of the current selection numerically. The units of display
are dependent on the

Working with Regions in the Sample Editor

When precision is important, the borders of regions should be
manipulated in the Sample Editor.
Region borders can be edited with to the precision of a single
sample word, if a high enough zoom setting is used. You can
also position the anchor, to change the part of the region used as
the position reference in the Arrange window. Remember that
the position display for a region in the Arrange window always
shows the position of the anchor, not the start point of the
region.
There are gadgets to adjust the start, anchor and end points of
a region, along the bottom edge of the Waveform
Emagic
210 Logic fun
S
key, and briefly clicking at the desired
O
key (Mac) or the
setting for the Sample editor.
View
ç
key (PC) while