Cycle Mode; Cycle Bars - Emagic Logic fun User Manual

Chapter 6
Transport Functions
6.3

Cycle Mode

In the cycle mode, you can isolate a passage of the song to be
repeated.
You may want to have a passage played repeatedly so that you
can:
•
edit events within the cycle zone
•
practice a section for recording
•
Record multiple takes
You can activate the cycle mode (repeat function) by:
•
clicking on the cycle button in the Transport
•
configuring a cycle bar in the bar ruler, by clicking in the
upper portion of the bar ruler
Setting Cycle Locators
The area to be played in cycle mode is defined by the cycle
locators.
Their values are shown in the Transport window, and can be set
there. See the section Position Indicators, pg 5-101.

Cycle Bars

When the cycle button is activated, you will see not only the
cycle locators in the Transport window, but also a white bar in
the bar ruler, that encompasses the cycle zone.
You can move the bar by grabbing it in the middle. To change
the bar's start or end position, grab the bar on the lower left or
right corner, and drag the edge to the desired spot. This way,
the left position can even overlap the right, or vice versa. By
holding down the
Emagic
104 Logic fun
S
key, you can set both borders as you like