Mobile - TC Electronic Konnekt 24D User Manual

SETUP EXAMPLES - "MOBILE STUDIO"
This is a typical small mobile setup with just a guitar,
a microphone and a laptop computer.
• Connect the guitar to ch 1, using a standard 1/4 inch
jack mono-mono, and set the PAD/inst to "in"
position. Set input level using the GAIN TRIM knob.
• Connect a microphone to ch 2 and use the PAD/inst
selector to correct input sensitivity.
If you have connected a condenser microphone the
+48 phantom power switch must be pressed.
• Connect your laptop computer using a standard
FireWire cable.
• Connect headphones to one of the two headphone
outputs. The upper connection will mute the main
outputs on the rear panes, but as nothing is
connected to the main outputs it is indifferent which
output you use.
18
If only one Konnekt is used and no other FireWire
devices are connected to the computer's FireWire
ports, Konnekt can be bus-powered directly from
the computer's FireWire port*. This is ideal when
recording in the field.
However, Konnekt does use power and will drain the
computers battery faster (especially if phantom power is
used), and we therefore recommend using a power
supply for either the computer and/or Konnekt when
possible.
* Please read the section regarding bus-power.