Table of Contents
Advertisement
Installation
The Integrator plug-in is automatically installed along with
the TC Near control panel.
Parameters
Device
Your setup may include several Konnekt units. Select the
Konnekt unit to which you are about to integrate an
external effect.
1st audio channel
Your DAW detects audio channels on the Studio Konnekt
48 and label these automatically. As the Integrator acts
as a stereo plug-in interface between the DAW and
external stereo devices, you always select two channels
(by default). These are identified by the name of the first
channel. In the illustration on the previous page, main out
1/2 is selected even though the label says "main out 1".
When inserting Integrator on a mono track it still
occupies a pair of channels.
Calibrate
Integrating external digital devices will introduce a short
latency, but your host application can be set up to
compensate for this using the Integrator calibrate
function.
•
Press CALIBRATE to measure the total roundtrip
latency including the latency within the external device.
The latency compensation feature of the host application
will then make sure to compensate for this latency.
This procedure should be carried out on each audio track
where Integrator is inserted.
Test & Auto
To verify that all cables to external units are properly
connected, a pink noise test signal can be sent to
left/right channels. Use L or R to send to left/right
channels individually. You may also press AUTO. Then
Integrator will send a pink noise signal that alternates
between Left and Right channels.
INTEGRATOR
57
Hide quick links:
Advertisement
Table of Contents
