TC Electronic Konnekt 24D User Manual page 14

FRONT PANEL OVERVIEW - KONNEKT 24D
Ch 3/4 (Konnekt 24D)
- Channels 3/4 (note that channel 3/4 are
always linked.
DI (Konnekt 8)
- Monitor the signal present on S/PDIF Digital
In.
User - The Setup page allows you to setup which
channel/channels are monitored when
"User" is selected. The options will vary
depending on the connected devices.
It is also possible to assign a level control of a channel to
the LED light-ring via the Mixer page on the TC Near
computer user-interface by pressing the light-ring icon on
the channel of your choice:
11 Output level
Sets the output level of analog outputs 1-2 and of the
head-phone outputs.
12 DSP Total Recall (Konnekt 24D only)
Three program settings can be stored in locations P1,
P2 and P3. These programs are total recall presets
recalling settings from both mixer page, setup page
and plug-in pages. Total recall of Fabrik plug-in
settings does not apply when routing is set to plug-in
mode.
12
- AUX (Konnekt 8 only)
On Konnekt 8 this section is replaced by a AUX
switch.
The AUX switch allows you to monitor the signal
present on the AUX inputs (rear panel)
An ideal function if you want to monitor e.g. a
keyboard thru the AUX inputs.
13 Phones muting
Connect a set of headphones here. Main outputs will
be muted.
14 Phones non muting
Connect a set of headphones here. Signal is still
passed to Main outputs.