TC Electronic Konnekt 24D User Manual page 25

Hide thumbs Also See for Konnekt 24D:
Table of Contents

Advertisement

1 The Konnekt select tabs
Channels1/2 & 3/4
2 Channels 1/2 - mono/stereo
The illustration on the previous page shows channels
1/2 in dual mono mode. The channels may be linked
to one stereo channel via the Setup page. This will
change the appearance of these channels. Please
refer to the description of the Setup page on the
following pages for details.
3 Ch1/Ch2 auto-sensing input
Channel 1/2 connections on the front panel are auto-
sensing. They automatically detect whether you have
connected an XLR (microphone) or 1/4" jack
(instrument), and indicate this graphically.
These are the options
Nothing connected
Mic
When an instrument jack is plugged you must press
Inst/Pad to activate the input. This is also indicated on
the setup page:
Ch3/Ch4
Connections for line channels 3/4 are located on the
rear panel.
THE CONTROL PANEL - MIXER PAGE
All Channels
4 Input Meters
5 Clip LED (RED)
6 Fabrik C symbols for channels 1/2
7 Send
8 Pan
Inst./jack
9 Out Level
10 Light Ring Assignment
11 Digital Channels
These meters indicate the level of the signal present
on the input channels. Best signal to noise ratio is
achieved when the input signal only occasionally
peaks at "0". Adjust the level on the sending device.
When the Clip LED is lit the signal is too hot. Reduce
the level on the sending device to compensate.
Press the symbol to activate/deactivate the Fabrik C
channel strip plug-in. Adjustment of Fabrik C
parameters is done via the Fabrik C page.
Use the SEND knobs to send signal from each
channel to the Fabrik R (reverb).
To actually hear the reverb make sure that Fabrik R is
active.
Pan left/right using the left mouse button.
Press Ctrl+Shift and left mouse button to center.
Master out level.
All faders with the "light ring" indication can
be assigned to the "source" controller on the
front panel. When assigned, the light ring on the front
panel displays the fader position.
The configuration of the digital channels is set via the
Setup page. Please refer to the description on the
following pages.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Konnekt 8

Table of Contents