Table of Contents
Advertisement
Cubase Installation
In the following we assume that you have already
followed the Konnekt Installation Guide.
•
Close all running applications.
•
Insert the Konnekt CD ROM in your CD rom drive.
•
The Konnekt Installer most likely opens automatically.
•
Close the application as we assume you have
previously followed the Installer once.
•
Browse the CD and click on the Cubase_LE_setup.exe file
located in the Cubase LE folder.
•
Follow the installation procedure to install Cubase.
Windows: - During the installation procedure you will be
asked to enter a serial number. This number is found on the
CD label.
Mac: - Unlike the Windows installation procedure, it is not
required to enter any serial number.
Selecting Konnekt as your audio interface in Cubase
•
Open Cubase.
•
Go to Devices - Device Setup
QUICK SETUP GUIDE
•
Select "VST Multitrack" in the left column
•
Select "ASIO TCNear" as Master ASIO Driver via the
drop-down menu in the right side of the display.
•
Click OK
Cubase Project examples
•
Create a new empty project.
•
Go to Devices - VST Inputs
In this menu you can activate/deactivate the Konnekt
inputs and also label these for your own convenience.
ASIO channel names / Port
The left column describes the physical input ports on
Konnekt. The center column holds on/off buttons for the
inputs. In the right column you are able to assign a name
of your choice to each input. Depending on the selected
sample rate there are limitations on available digital
channels. Please refer to the appendix section to see the
ASIO channel names and distribution.
In Cubase LE for Macintosh the VST inputs are not
named automatically. However, you may enter channel
names of you choice. For Konnekt 24D we suggest using
the names as they appear in the screenshot above.
7 7
Hide quick links:
Advertisement
Table of Contents
