TC Electronic Konnekt 24D User Manual page 57

Additional parameters
Bypass
Bypass function for the entire plug-in.
In/Out
In level Range : -24 to 0dB
Out level Range : -24 to +12dB
Sets the Input/Output levels for the algorithm. If the
Internal overload indicators "O/L" are lit, you may need to
readjust the In/Out levels.
Meters
In and output meters. For best performance the In meter
should show as close to 0dB as possible without clipping.
Kill Dry - Kill wet
A reverb can be used either as an insert effect or as a
send effect.
Most often it is used as a send effect on a bus. The bus
is fed from the channels you apply the effect to. When
used as a send effect the Kill Dry should be set to "on"
and this is also the default setting. When used as an
insert channel, dry signal is necessary and Kill Dry
should be set to "off".
Routing
The routing options for Fabrik R can be set both on the
Setup page under DSP EFFECTS SETTINGS and on the
Fabric R page itself.
The options are:
- Internal
- Computer s/r stereo
- Computer s/r dual mono
Please see further descriptions of these routing modes in
the manual section describing the Setup page.
At 96kHz, USE
At 96kHz (and 88.2) it is not possible to run both the
Fabrik C and the Fabrik R plug-ins.
Select either Fabrik C or Fabrik R.
FABRIK R
55