Table of Contents
Advertisement
9 Mixer View
Show
Determines whether the link channels should appear on
the mixer page.
Stereo Link
Press to stereo-link the link channels on the mixer page.
Output
In this section of the Setup page you set up signal
routing to the Konnekt outputs.
10 Source for Line 3-4 & S/PDIF outputs
DAW
When DAW is selected, the signal from your HD
recording application (e.g. Cubase) is routed to the
outputs. (Daw Line 3+4, Daw optical S/PDIF, Daw
adat or Daw coaxial S/PDIF).
Mic/Inst/Line
This is the option to use if you want to route the
signal present on the Mic/Inst/Line connections on
the Konnekt front panel to the outputs.
Konnekt Mixer
When Konnekt mixer is selected the main out signal
from the Konnekt mixer page is routed to the outputs.
Mixer Send Knobs
On the Konnekt mixer you have the option of sending
a signal to the Fabrik reverb *), using the channel
send knobs.
However, you may choose to route the send to any of
the routable outputs (all outs but main outs, which are
always set to listen to the Konnekt mixer). This is
great if you want to use an external effect with your
monitor mix.
Example: External effect using S/PDIF
11 OPTICAL outputs (Konnekt 24D only)
ADAT
Select ADAT to send up to 8 ADAT channels on the
Lightpipe out connection.
OPTICAL S/PDIF (TOS link)
Select OPTICAL S/PDIF to send 2 channels of optical
S/PDIF to the Lightpipe out connection (TOS link).
SOURCE
Same options as with the Line3+4 and S/PDIF
output sources.
*) Konnekt 24D only
SETUP PAGE
29
Hide quick links:
Advertisement
Table of Contents
