2-2 Software Installation; 2-2.1 Windows 95 Driver Installation - SIIG CyberParallel Dual Installation Manual

2-2 Software Installation

This section provides information on how to install the
CyberParallel Dual's drivers for the following operating systems:

2-2.1 Windows 95 Driver Installation

To ensure proper installation in your system, verify the
version (4.00.950, 4.00.950B or 4.00.950C) of Windows 95 in
your system and follow the installation procedures
accordingly. To verify version, go to My Computer/Control
Panel/System/General
Follow the procedures listed below to install the Windows 95
drivers:
1. When you first turn on your computer after installing the
board, Windows will notify you of "New Hardware
Found".
2. For version 4.00.950 user, select "Driver from disk provided
by hardware manufacturer" and click on "OK".
(For version 4.00.950B or 4.00.950C user, the "Update
Device Driver Wizard" dialog box will appear, click on
"Next")
3. Insert the Driver Installation diskette in the floppy drive
and type in a:\Win95 and click on "OK".
(For version 4.00.950B or 4.00.950C, check "Other
Locations" and type in a:\Win95, click on "OK", and
then "Finish". From the "Insert Disk" window, click on
"OK". When the "Copying Files" dialog box appears,
type in a:\Win95 and click on "OK" again.)
4. Remove the diskette and select "Yes" to restart the
computer for the setup to take effect.
Windows 95/98
Windows NT 4.0
DOS/Windows 3.1x
Installation
2-3