2-2.4 Dos/Windows 3.1X Driver Installation; Changing The I/O Address In Windows Nt 4.0 - SIIG CyberParallel Dual Installation Manual

Hide thumbs Also See for CyberParallel Dual:
Table of Contents

Advertisement

CyberParallel Dual User's Manual
To change the I/O address in Windows NT 4.0:
1.
Go to Start / Setting / Control Panel, double-click on
SIIG Cyber PCI 20X device icon.
2. Highlight the LPT address you want to change and click
on Setting.
3.
Select or type in an I/O address supported by the device
you would like to configure and click on "OK". Make
sure the selected I/O address does not conflict with
other device in your system.
4.
Select Restart Now for the new setup to take effect.

2-2.4 DOS/Windows 3.1x Driver Installation

Follow the steps listed below to install the drivers for DOS/
Windows 3.1x:
1.
Insert Driver Installation diskette in the floppy drive and
from the C:\> prompt, type in: copy a:\dos\*.* and press
<Enter>.
2.
Type in: edit autoexec.bat and press <Enter>.
3. Add C:\CB20XPC.exe at the bottom of the autoexec.bat
file.
4. Go to File, save the changes and exit.
5. Remove the diskette and restart the system for the new
setup to take effect.
2-6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CyberParallel Dual and is the answer not in the manual?

Table of Contents