SIIG 2-Port Serial 950-Value Quick Installation Guide Introducing the SIIG 2-Port Serial 950-Value The SIIG 2-Port Serial 950-Value high-speed serial I/O card provides two additional 9-pin serial ports. Features and Benefits • Conforms to PCI v2.2 Plug and Play •...
Layout Serial Port 2 Serial Port 1 Figure 1. Layout Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed. Static Electricity Discharge may permanently damage your system.
Replace the computer cover and reconnect the power cord. Software Installation This section provides information on how to install the SIIG 2-Port Serial 950-Value drivers. Windows 7 (32-/64-bit) Right click Computer, click Manage, click Device Manager. Insert the driver CD. Right click PCI Serial Port, click Update Driver Software.
Page 4
Windows Vista (32-/64-bit) At the Found New Hardware window, insert the driver CD, click Locate and install driver software (recommended), click Continue. Click Don't Search Online, Next, then click Close. Repeat step 2 to complete the driver installation. Windows XP (32-/64-bit) / Server 2003 (32-/64-bit) At the Found New Hardware Wizard, insert the driver CD.
Page 5
Click on the + (plus sign) in front of Ports (COM & LPT), CyberSerial 950 16Cxxx... should be displayed two times. Double click Multifunction adapters, SIIG CyberPro 2S board should be displayed. Windows 2000 At the Found New Hardware Wizard, click Next.
Page 6
Click on the + (plus sign) in front of Ports (COM & LPT), CyberSerial 950 16Cxxx... should be displayed two times. Double click Multifunction adapters, SIIG CyberPro 2S board should be displayed. Windows ME At the Add New Hardware Wizard, select Specify the location of the driver (Advanced), then click Next.
Page 7
Right click My Computer, click Properties, then click Device Manager. Double click Ports (COM & LPT), CyberSerial 950 16Cxxx... should be displayed two times. Double click Multi-function adapters, SIIG CyberPro 2S board and PCI Function should be displayed. Windows NT 4.0 From the desktop click Start, then Run.
Page 8
Click Yes, then click Exit. Restart Windows to complete the installation. To Verify Windows NT 4.0 Installation Click Start, Settings, Control Panel. Double click Ports device icon. Two new COM ports will be assigned when successfully installed.
Page 9
Changing COM Port Address Some serial devices need a specific COM port in order to work. If your serial device works properly, do not change this setting. Windows 7 / Vista / XP / Server 2003 & 2008 / 2000 From the Device Manager window, double click Ports (COM &...
Step 1: Submit your RMA request. Go to www.siig.com, click Support, then RMA to submit a request to SIIG RMA. Your RMA request will be processed, if the product is determined to be defective, an RMA number will be issued.
Page 12
Fremont, CA 94538-3152, USA Phone: 510-657-8688 SIIG 2-Port Serial 950-Value is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. All other names used in this publication are for identification only and may be trademarks of their respective owners.
Need help?
Do you have a question about the SIIG 2-Port Serial 950-Value and is the answer not in the manual?
Questions and answers