2-2.3 Windows Nt 4.0 Driver Installation - SIIG CyberParallel Dual Installation Manual

2-2.3 Windows NT 4.0 Driver Installation

Follow the steps listed below to install the Windows NT 4.0
drivers:
1 Go to Start and Run.
2. Insert the Driver Installation diskette in the floppy drive
and type in: A:\NT4\setup, then click on "OK".
3. The "Welcome" window will appear. Click on "Next".
4. From the "Choose Destination Location" window, click
on "Next".
5. From the next "Setup Complete" window, select "Yes, I
want to restart my computer now" and click on "Finish".
6. Remove the diskette and restart the computer for the
setup to take effect.
To verify successful installation in Windows NT 4.0:
1. Go to Start / Setting / Control Panel, double-click on
SIIG Cyber PCI 20X device icon.
2. New LPT numbers will be assigned for the parallel ports
when successfully installed. The board is ready to
connect printers.
Note If you plan to connect a parallel device other
than a printer, such as zip drive, scanner etc, please
follow the next section to change the port's I/O address
to support the device.
Installation
2-5