AMX Epica DGX 16 Instruction Manual page 29

Distribution matrix
Table of Contents

Advertisement

Attaching Cable Management Bars
AMX AutoPatch cable management bars are provided for DGX SC Optical Input and Output Boards.
Caution: Do not severely bend or kink the SC fiber cable. Irreversible damage can occur. Refer to
the physical limitations (bend radius) specified for the cable by the manufacturer. The bend radius
for AMX SC terminated fiber cables is 2 inches (5 cm).
To install cable management bars:
1.
Epica DGX 32 only – Loosen the two captive screws that hold the connector numbering plate at the
top of the connectors. Remove the connector numbering plate and set aside.
FIG. 11
Connector numbering plate
2.
Align the two screw holes on the end of the cable management bar with the two screw holes on the
end of the board as shown in FIG. 12. (Note the position of the long part of the bar in relation to the
screw holes.)
Note: On the Epica DGX 16, the orientation of the cable
management bar is reversed from the input to the output board.
FIG. 12
Installation of cable management bars (Epica DGX 32 top and Epica DGX 16 bottom)
3.
Insert and tighten the two screws at the end of the cable management bar (do not over tighten the
screws).
4.
Align, insert, and tighten the single screw at the other end of the cable management bar (do not over
tighten).
5.
Tie the cable to the cable management bar far enough from the connector to allow for the
manufacturer's recommended bend radius. The bend radius for AMX SC terminated fiber cables is
2 inches (5 cm).
6.
Epica DGX 32 only – Replace the connector numbering plate that was removed in Step 1.
Epica DGX 16 and Epica DGX 32 Instruction Manual
Fasten cable management bar with
two screws on one end and one on
the other end (do not over tighten)
Epica DGX 32
Epica DGX 16
Input board
Connector numbering plate
Tie cable to cable management
bar far enough from connector
to allow for manufacturer's
recommended bend radius
Output board
Installation and Setup
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epica dgx 32Enova dgx 16

Table of Contents