Changing The Proxy Setting - AMX Epica DGX 16 Instruction Manual

Changing the Proxy Setting

If the NXB-AP-1000 Interface does not open during setup, try the following troubleshooting strategies:
If the NXB-AP-1000 Interface still does not open, you may need to add an exception in the Proxy
Setting dialog box.
The following instructions apply to Internet Explorer. To change these settings in another browser,
consult its Help file.
To add an exception to the proxy setting information:
1.
From the Tools menu on the browser, select Internet Options.
The Internet Options dialog box opens.
Epica DGX 16 and Epica DGX 32 Instruction Manual
Check all power, signal, and link connections on all of the equipment.
Check LED indicators for the TCP/IP (RJ-45) connector on the Epica DGX 16 or 32.
If the LED indicators are not illuminated, check the cable type to make sure it meets cable
requirements (see page 43).
Check LED indicators on the NetLinx Master.
Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XXX.XXX
(where XXX.XXX.XXX.XXX is the NXB-AP-1000 Interface IP address; see page 80).
Try connecting to the NXB-AP-1000 Interface again.
NXB-AP-1000 Interface – Additional Info for Network Admin
101