AMX Epica DGX 16 Instruction Manual page 92

NXB-AP-1000 Interface – Initial Setup by Network Admin
Note: If you enable a Security Setting and then click Accept without specifying Login Information,
the login defaults apply (see below).
Setting Login Information
The Login Information settings are required only if one or more of the security settings are enabled.
To set the login information:
1.
Username – Enter the Username that will be required to log into the system if security is enabled.
The default Username is administrator.
2.
New Password – Enter a new password that will be required to log into the system if security is
enabled. The default Password is password.
3.
Confirm Password – Re-enter the new password in this field.
4.
Click Accept to save the changes (or click Cancel to cancel the changes).
The changes take effect immediately.
Note: If the Security Settings are disabled and then enabled again, the Login Information remains in
affect.
Login when Security is Enabled
Logging into pages in the interface is a requirement only if the Web Security option and/or the Admin
Security option are enabled.
To log into the Configuration Manager when security is enabled:
1.
Click the Login link in the upper-right corner of any page.
The Login dialog box opens.
2.
Enter the login information specified during security setup (see above).
3.
Click the Login button.
86
Default Username = administrator
Default Password = password
Epica DGX 16 and Epica DGX 32 Instruction Manual