Table 6. Switch Base-T Led Descriptions - Allied Telesis 48Ts/X Installation Manual

Table 6 describes the LEDs for the Base-T ports.

Table 6. Switch Base-T LED Descriptions

LED Function
L/A Link Status
and Activity
Duplex
D/C
Mode and
Collisions
Power over
PoE
Ethernet
Status
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
State
Off No link has been established between
the port and the end node.
Solid The port has established a link at
Green 1000 Mbps.
Flashing Packets are being received or
Green transmitted at 1000 Mbps.
Solid The port has established a link at 10
Amber or 100 Mbps.
Flashing Packets are being received or
Amber transmitted at 10 or 100 Mbps.
Solid The port is operating in full-duplex
Green mode.
Solid The port is operating in half-duplex
Amber mode (only applies when operating at
10 or 100 Mbps).
Flashing Collisions are occurring on the port
Amber (only applies when operating at 10 or
100 Mbps, half-duplex mode).
Off There is no powered device detected.
Solid The end node is a powered device
Green and the port is providing power to it.
Solid The port is experiencing a problem
Amber providing PoE to the end node.
Flashing The port is connected to a powered
device but providing power to it would
Amber
exceed the maximum PoE power
budget of the switch.
Description
37