Starting A Local Management Session; Figure 60. Connecting The Management Cable To The Rj-45 Terminal Port On The Switch - Allied Telesis 48Ts/X Installation Manual

Starting a Local
Management
Session
The following procedure describes how to connect an RJ-45 cable to an
x610 switch. For information about how to log onto the AlliedWare Plus
Operating System Software, see the AlliedWare Plus Operating System
Software Reference Guide.
To start a local management session on the unit, perform the following
procedure:
1. Connect the RJ-45 end of the management cable included with the
x610 switch to the Terminal Port on the front panel of the switch, as
shown in Figure 60.
1 5
1 7
1 9
1 6
1 8
2 0
Figure 60. Connecting the Management Cable to the RJ-45 Terminal Port
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
3. Configure the terminal or terminal emulation program as follows:
Baud rate: Default is 9600 bps (Range is 9600 to 115200 bps)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
2 1 R
2 3 R
2 1
S F P
2 3
2 2 R
2 4 R
2 2
1 0 0 0
/
1 0 0
2 4
on the Switch
R E A D
Y
B U S Y
FA U LT
S D
CL AS
LA SE S 1
R PR OD
UC T
S T A C
K
M S T R
S T A T
U S
FA U LT
L/ A
1
M A S T
L/ A
E R
2
P R E S
R P S
C O N
S O L E P W R
2076
101