Table of Contents
Advertisement
SATA1/ SATA2
The SATA connectors support transfer rate to 150 MB/s and SATA RAID 0 or 1 mode. The connectors
only can connect one serial ATA hard disk device each.
1
7
JSATA1~2
Headers & Jumpers
Front USB Headers: USB3 USB4
You can connect the USB Bracket to the USB3/ USB4 header. The mainboard supports up to eight USB
devices including four on the back panel.
2
1
JUSB3/JUSB4
USB Bracket (optional)
You can connect the USB bracket to the USB3/ USB4 headers.
If you are using USB 2.0 devices with Windows® 2000/ XP,you will need to install the USB
2.0 driver from the Microsoft
Clear CMOS Jumper: JP1
The "Clear CMOS" jumper is used when you cannot boot your system due to some CMOS configuration
problem such as a forgotten password. This jumper allows you to reset the CMOS configurations, and
then reconfigure.
The following procedures are for resetting the BIOS password. It is
important to follow these instructions closely.
1.
Turn off your system and disconnect the AC power cable.
2.
Set JP1 to OFF (2-3 Closed).
3.
Wait several seconds.
4.
Set JP1 to ON (1-2 closed).
5.
Connect the AC power cabl
password.
Pin
Assignment
1
Ground
3
TX-
5
RX-
7
Ground
Pin
Assignment
1
+5V (fused)
10
3
USB-
5
USB+
7
Ground
9
Key
®
website.
e and turn on your system.Reset your desired
13
PM800 Pro(V2.0)
Pin
Assignment
2
TX+
4
Ground
6
RX+
Pin
Assignment
2
+5V (fused)
4
USB-
6
USB+
8
Ground
NC
Advertisement
Table of Contents
